Z SERIES SUPERMETALLIZED
POLYPULSE CAPACITORS FOR SWITCHING POWER SUPPLIES
LOW ESR •
HIGH CURRENT • HIGH FREQUENCY
These
SuperMetallized PolyPulse Capacitors are specifically designed for high
current, high frequency applications like switching power supplies.
CONSTRUCTION:
|
Low loss SuperMetallized PolyPulse dielectric; extended foil, with high current end terminations. Type ZW Series are encased in a skin tight flame retardant* plastic wrap with epoxy end fill. *UL 510 Specification. |
CAPACITANCE: |
Measured at +25° C @ 1000Hz. MIL STD 202 Method 305 |
DISSIPATION
FACTOR: INSULATION
RESISTANCE: DIELECTRIC
STRENGTH: CURRENT
STRENGTH: EQUIVALENT SERIES RESISTANCE: |
Shall be less
than 2.0% at 100 KHz and +25°C for <5.0 mfd. Ref: MIL STD 202 Method 305 Shall be
greater than 100,000 megohms/microfarads, but need not exceed 200,000 megohms
measured at +25°C and electrified at 100VDC for two minutes maximum. Ref: MIL
STD 202 Method 302. Terminal to
terminal 150% of the rated DC voltage. The discharge
of the DC rated voltage (need not exceed 200VDC) through a 2 milliohm mercury
relay 1000 X shall result in no significant change in ESR. Maximum ESR in milliohms @ 100KHz and +25° C |
CAPACITANCE
CHANGE: AC VOLTAGE: RMS CURRENT: |
Maximum
capacitance change with temperature is 1% @85°C and 2% @+125°C The sum of the
DC and Peak AC voltage applied to the capacitor should not exceed the rated
DC voltage, nor should the RMS voltage exceed 220VAC. Maximum RMS ripple current in amps @ +25°C @ 20-200KHz. See limits in table. Derate current 10% for every 25°C increase in temperature above 25°C. |
PEAK CURRENT: |
|
DV/DT: LEADS: |
Maximum
allowed change in volts per microsecond at the rated voltage. See limits in table. Tin plated copper wire. |
OPERATING TEMPERATURE: |
-55° C to +125° C without voltage derating |
SuperMetallized
PolyPulse Size Data
Part Drawing ZW Series Oval Wrap and Fill
Current Wave Forms and Calculations
Updated: September 20, 2001
Copyright © 2001 American Capacitor
Corporation. All rights reserved.